I have modeled a RED LED in model editor but when i am adding the smoke parameters for this model.they are not picked up in the SMOKE ANAYLSIS.Can anyone Explain the reason
Hi,
Could you send your model to evaluate please? Let me also know which parameters are not taken in Smoke. Or is the complete model not taken for Smoke?
Thx
Hi Robert
I cannot see any attachment options here for atatching the word document.
I am trying to attach images but they are also not getting attached
If you have some mail id i can directly mail it to you
Regards
Niti
.MODEL LED1 D (IS=93.2p RS=42m N=3.73 BV=4 IBV=10u + CJO=2.97p VJ=.75 M=.333 TT=4.32u)
This the model i used.I am using PSPICE A/D
OrCAD Lite
Installed: 17.2-2016 Lite
Latest: Undetermined
I am not able to attach all the screenshots
You can attache images if you use Internet Explorer :)
Copyright © 2020 Cadence Design Systems, Inc. All rights reserved.
Terms of Use | Privacy
Hi,
Could you send your model to evaluate please? Let me also know which parameters are not taken in Smoke. Or is the complete model not taken for Smoke?
Thx
Hi Robert
I cannot see any attachment options here for atatching the word document.
I am trying to attach images but they are also not getting attached
If you have some mail id i can directly mail it to you
Regards
Niti
Hi Robert
I cannot see any attachment options here for atatching the word document.
I am trying to attach images but they are also not getting attached
If you have some mail id i can directly mail it to you
Regards
Niti
.MODEL LED1 D (IS=93.2p RS=42m N=3.73 BV=4 IBV=10u
+ CJO=2.97p VJ=.75 M=.333 TT=4.32u)
This the model i used.I am using PSPICE A/D
OrCAD Lite
Installed: 17.2-2016 Lite
Latest: Undetermined
I am not able to attach all the screenshots
Hi,
You can attache images if you use Internet Explorer :)