Hello,
I have a little problem.
I need to put a few simulation results in 1 diagram but i don't know how i can do that.
For exaplme:
Circuits with 50uF capacitor and 10 Ohm resistor + 50uF/20 Ohm + 100uF/10 Ohm + 100uF/20 Ohm ... etc.
Can someone help me?
Greetings,
joshmx
Copyright © 2020 Cadence Design Systems, Inc. All rights reserved.
Hi Joshmx,
Are you asking how to use different schematics in your project?
If so, you can create a hierarchical design and change the implementation when you want to simulate the other circuit.
Eg. In OrCAD Capture - File - New - Project - select the hierarchical.opj in dropdown and Ok
This will help you create such a project.
Depending on your needs, a parametric sweep for the capacitor and resistor value may be easier. Eg. set Capacitor C1 value to {CAPVAL} and place the VARIABLES part to define a parameter to sweep. Remember to setup the parametric sweep in the simulation profile in the end.
Kind regards,
Anders