I have a strange problem, the Smoke analysis wl not work, even they not show any error and warning about problem.
Transient, bias simulation work correct, but smoke will not process correct.
The screen are quite small... Could you send cir File or project?
Below you could find the testcases.
IAfter unzipping the circuit, I found that you have used a diode which is not as part of installation. As I did not have the lib file for that one, I went ahead and replaced it with another available diode in PSpice library and I was successfully able to run Smoke analysis on it.
This made me conclude/think that you are probably missing the necessary Smoke parameters in your model which are required for the Smoke analysis to run,
Please add them to your model, and then run Smoke on the ckt.
Let us know if that worked.
Copyright © 2018 Cadence Design Systems, Inc. All rights reserved.