Back to Forums
6 posts / 0 new
Last post
#1 Feb 2, 2020
chrispv7
Offline
Last seen: 4 years 1 month ago
Joined: 2020-02-02 07:41

Unable to Move Cursor all the way to right on plots

Whenever I try to use the cursor to analyze various traces, the cursor hits an invisible wall in my plot and won't move all the way to the right of the trace. For instance, when i try to move along the x-axis which has a limit of 12, it won't move past 11.5. Please advise.

Mon, 2020-02-03 10:48
spice_up_your_c...
Offline
Last seen: 3 years 9 months ago
Joined: 2020-01-26 09:49

Hi Chris,

What version of the software are you using? I tried it out in version 17.4 and it's working correctly. For example, I can see the cursor going to the end limit of the X-axis 

 

Mon, 2020-02-03 11:04
chrispv7
Offline
Last seen: 4 years 1 month ago
Joined: 2020-02-02 07:41

I am running version 17.2

Mon, 2020-02-03 12:10
spice_up_your_c...
Offline
Last seen: 3 years 9 months ago
Joined: 2020-01-26 09:49

I just checked in v 17.2 and the cursors worked fine till the end of limit. 

Maybe, you have one of the pre-defined cursor operations enabled (max, min, avg, trough etc) which makes it stop around 11.5 in your case. Kindly check that.

If the issue still persists, please reach out to your OrCAD Channel partner for assistance or Cadence online support

Fri, 2023-07-14 23:49
michaelarrington
Offline
Last seen: 1 month 4 weeks ago
Joined: 2023-04-05 21:04

Make that the x-axis range is not restricted or that no fixed boundary is established by the plot settings or the software you are using to create the graphs. Check for any special settings affecting the x-axis restrictions or cursor control 

autistic test

Thu, 2023-08-10 02:38
nihaw51833
Offline
Last seen: 7 months 3 weeks ago
Joined: 2023-06-29 06:42

I am running version 17.2

Geometry Dash Scratch

Download PSpice and try it for free! Download Free Trial
Cadence