What behavior should I use to realize ccvs (current-controlled voltage source) ?
I didn't find models with current input.
I tried this one, but this way it doesn't work.
Don't use an ABM part. From your schematic select Place/PSpice Component/Source/Controlled Sources/CCVS. This is an H part (from the analog.olb library).
For CCVS from this library the only parameter is GAIN, whereas I'm looking for mor complex source.
In the meantime I've found the EVALUE component from ABM library.
But it doesn't do what I expect - instead of Gaussian output (when running dc sweep) it gives strignt line.
It seems that exp function doesn't work.
In the shematic below - E1, E2 fail, E3 - Ok, but EXP output also fails.
Any comments ?
This seems to be fine, as in the output isn't a straight line, with PSpice for TI S004 and with a licensed PSpice installation, for a DC Sweep from 0 to 1V with steps of 10m.
Don't understand what you mean. The iuput is straight line, in the cases where exp function is present.
I'm not aware what TI S004 is.
"But it doesn't do what I expect - instead of Gaussian output (when running dc sweep) it gives strignt line" (sic) So from this it looks like you are getting a straight line at the output, or not? As I mentioned the output that I get with your "E1" circuit is not a straight line so, I would say, that there isn't an issue with the EXP function. The PSpice for TI has a version, the latest appears to be S004. (Since this post is in the PSpice for TI section, I reasoned that might be the PSpice installation that was being used)
Honestly, The method of your explanation is very good. I like it the most. best air purifier and humidifier , best air purifier to buy
Copyright © 2020 Cadence Design Systems, Inc. All rights reserved.