How to save and initialize param of device in simulation?
Some params in the device would change after simulation, and I want those params be saved and initialized in next simulation. How can I do that? Thanks.
You can use checkpoint and restart feature. Saving a checkpoint would save entire circuit state at any configured point of transient simulation. This can then be used to restart the new simulation from that circuit state. Similarly one can save Bias point and use it.
How amazing this article is!!! It is the article which can help me to look back on myself while reading an article about 메이저놀이터 , and to grow in the future rather than always beating myself up and staying in one place.
You can use checkpoint and restart feature. Saving a checkpoint would save entire circuit state at any configured point of transient simulation. This can then be used to restart the new simulation from that circuit state. Similarly one can save Bias point and use it.
Thanks for sharing this post. I am also facing this problem and working on it. Your article is very helpful to me spades online
How amazing this article is!!! It is the article which can help me to look back on myself while reading an article about 메이저놀이터 , and to grow in the future rather than always beating myself up and staying in one place.