I've recently updated to V 2021.1. It used to be that after the simulator had completed about 20% of the run, it would start displaying a grid and as much of the waveform as it had completed so far but after this update there is no waveform or even waveform grid displayed until the simulation has fully completed. That is highly inconvient because a complete run takes about 30 minutes so Is there a setting that can restore it to the original display-as-you-go mode?
Thanks
Robert Phillips
Copyright © 2020 Cadence Design Systems, Inc. All rights reserved.
Under simulation settings, go to Probe Window option in the left pane and select "during simulation" checkbox under "Display Probe Window" and it will enable tool to display the waveform during simulation
Hi ayush,
Thanks for prompt reply. Fixed the issue. I had hunted through the User manuals but somehow this evaded me.
Best Regards
Robert